Hammer K2 M - Fit;Change the Riving Knife

17
K2 M - Part 2/2
Adjustments and tool changes
1.4.3 Fit /change the riving knife
1
2
3
4
5
Fig. 12: Fitting the riving knife
1 Clamping screw
2 Riving knife
3 Serrated washers
4 Bolts
5 Saw blade
Tool:
● Combination wrench 17 mm
1.
Loosen the clamping screw.
2.
Remove the riving knife if required.
3.
Insert the riving knife into the holder.
🡆
The riving knife holder bolt must sit in the riving knife groove.
4.
Move the riving knife into the correct position. ⮫
Chapter 1.4.2 ‘Loosen /
adjust riving knife’ on page 15
5.
WARNING F
lying pieces
Severe injuries and damage to property.
● Minimum tightening torque of the clamping bolt: 25 Nm.
Tighten the clamping screw.