Hammer K2 M - Page 39

39
K2 M - Part 2/2
Maintenance
3.
Push the [Emer
gency stop].
Machine stops immediately.
1.
Continue with next step.
Machine does not stop immediately.
1.
If present: Switch off [Main s
witch] (position "O" / "OFF").
2.
Disconnect the machine from the mains power supply.
3.
Contact Felder-Group service centre.
4.
Switch the machine on using the green [s
tart] button with the [emergency
stop] button locked.
Machine does not start.
1.
Unlock the [Emer
gency stop] button by turning it.
2.
Repeat with all [Emer
gency Stop] buttons on the machine.
Machine can be started.
1.
Press the red [S
top] button.
2.
If present: Turn the [main s
witch] off (position "O" / OFF)
and secure it.
3.
Contact Felder-Group service centre.
Check the red
[stop] button and the emergency stop on machines not equipped with an [emergency stop] button
Carry out emergency stop test with all red [Stop] buttons on the machine.
1.
Prepare the machine to operate.
2.
Switch machine on.
3.
Press the red [S
top] button.
Machine stops immediately.
1.
Repeat the test on the next red [S
top] button.
2.
Repeat with all red [S
top] buttons on the machine.
Machine does not stop immediately.
1.
If present: Switch off [Main s
witch] (position "O" / "OFF").
2.
Disconnect the machine from the mains power supply.
3.
Contact Felder-Group service centre.
Check the time it takes for the machine to come to a stop
C
onfiguration of the machine without a motor brake:
The machine is not equipped with a motor brake. The design of the machine
guarantees that the saw arbour comes to a standstill within the legally applicable
standstill time of 10 seconds.
1.
Prepare the machine to operate.
2.
Switch the machine on and briefly let it run.