Fault description Cause Remedy
Safety limit switch without func-
t
ion
Fault in the electrical system
2.
C
ontact Felder-Group service
centre.
Machine cannot be switched
of
f
Fault in the electrical system /
[Emergency stop] - command
chain
1.
Disc
onnect the machine from the
mains power supply.
2.
Contact Felder-Group service
c
entre.
Machine is not functioning Error in the electrical connection
Check the electrical connection
(
power cable, fuses).
Circular saw shaft doesn't start Safety limit switch not actuated
(
insert board removed)
Prepare the machine to operate.
[Motor safety switch] ha
s been
triggered
Let the motor cool down, restart
the mac
hine.
The motor is running but the
s
aw blade is not rotating
The drive belt is torn
Replacing the drive belt.
The belts squeal when
s
witched on or started
The belt tension is too slack
Check belt tension, retighten if
nec
essary.
The drive belt is worn out
Replacing the drive belt.
Saw blade cannot be brought
to a stop within 10 seconds
Fault in the electrical system /
brake
Contact Felder-Group service
centre.
Fault on the machine - mechanical
Fault description Cause Remedy
The height of the rip fence
guide abo
ve the machine table
is not correct
The height adjustment is misad-
justed
Readjust the height of the guide.
The rip fence angle is not cor-
r
ect
The angle adjustment is misad-
justed
Readjust/correct the rip fence angle.
Unsatisfactory cuts Saw blade is blunt or incor-
r
ectly selected for the work-
piece
Changing the saw blade.
Cutting height is set too high Only set the cutting height to the
hei
ght actually required.
To Next Page
Loading...
