Hantek IDSO1070 series User Manual

PC Application
User’s Manual 39
The Trace cursor measure result display on status bar:
3) Vertical
The Vertical cursors appear as vertical lines on the display and measure the vertical parameters.
Do these steps:
1. Click “Cursor”-> “Source” select CH1 (select CH2 if you want measure CH2).
2. Click “Cursor”-> “Type”, select Vertical.
3. Push left mouse button, and the vertical lines appear.
4. Drag the mouse button to the point you want to measure.
5. Release the left mouse button, the frequency and time difference will be shown at the status
bar.
The Vertical cursor display window:
The Vertical cursor measure result display on status bar:
4) Horizontal
The Horizontal cursors appear as horizontal lines on the display and measure the horizontal
parameters.
Do these steps:
1. Click “Cursor”-> “Source” select CH1 (select CH2 if you want measure CH2).
2. Click “Cursor”-> “Type”, select Horizontal.
3. Push left mouse button, and the Horizontal lines appear.
4. Drag the mouse button to the point you want to measure.

Hantek IDSO1070 series Specifications

General

Brand	Hantek
Model	IDSO1070 series
Category	Test Equipment
Language	English