11 4000670450 E 04.19 USA / GB
3632T - HTT13
A
- Foreword
2.1.2 - Falling Hazards
To enter or exit from the platform :
• The machine must be completely stowed.
• Face the machine to access the entry opening to the platform.
• Keep 3 points of contact (both hands and a foot) on the steps
and the guardrail.
Before commencing operation :
• Ensure that guard rails are correctly installed and secured.
• Ensure that gate or sliding bar is in it’s proper closed position.
• Remove oil or grease from the steps, floor, handrail and the
guardrails.
• Clear the platform floor free of debris.
When in the platform :
• Occupants must wear a fall arrest harness with energy
absorber, in accordance with applicable governmental
regulations. Attach the lanyard to the designated fall arrest
anchor provided in the platform.
• The correct use of the harness requires the lanyard to be
connected to an anchorage point designated by the decals.
Refer to this decal located on the platform.
• Hold on securely to the guardrails.
• Always keep your feet firmly on the floor of the platform.
• Do not sit, stand, or climb on the platform guard rails.
• Work only within the platform guardrails area and do not lean
over guardrails to perform work.
• Do not exit the platform until it is in the completely stowed
position.
• Do not use the guardrail as a means of access to climb in or
out of the platform.
To Next Page
Loading...
