Haulotte HTT13 - Platform Control Box; To Start and Stop the Machine; Boom and Arm Controls

68 4000670450 E 04.19 USA / GB
D - Operation instructions
3632T - HTT13
3 - Platform control box
3.1 - TO START AND STOP THE MACHINE
Refer to Section B 3.3 - Platform control box.
To start the machine :
At the ground control box :
• Check that the E-stop button ( 6 ) is not pressed in.
• Turn the control box key selector ( 1 ) on position ( 1a ) to energize the machine and activate
the platform control box.
At the platform control box :
• Check that the E-stop button ( 5 ) is not pressed in.
• Start a cold engine by pressing (pushing) in and holding the CHOKE ( 2 ) button then press
(push) the ENGINE START ( 1 ) button.
• To start / restart a warm engine, press (push) the ENGINE START ( 1 ) button only.
• Allow the engine to heat up and initialize.
To stop the engine :
• Turn off the power supply of the machine using the Control box activation key switch ( 1 )
to position.
3.2 - BOOM AND ARM CONTROLS
Refer to Section B 3.3 - Platform control box.
Platform box controls (driving station) :
• Must press (push) in and hold a desired SPEED/
ENABLE button ( 6 ) simultaneously with desired
control button.
Command Action
Raising / lowering of arm
Press the arm raising control ( 9 ) upwards to raise the
arm
Press the arm lowering control ( 10 ) downwards to lower
the arm