Haulotte HTT13 - Inspection Form

A
B
C
D
E
F
G
H
I
55 4000670450 E 04.19 USA / GB
C - Pre-operation inspection
3632T - HTT13
3.2 - INSPECTION FORM
Inspection Form for Haulotte Aerial Work Platforms
Machine Model No. Serial No.
Date of Manufacture :
Inspection
Performed by :
Date of inspection :
Inspection
Location :
Inspection and Maintenance of the above listed machine shall be performed only by fully trained, authorized
and, where applicable, certified personnel. All service checks shall be performed in accordance with
manufacturer's recommendations (Refer to the Maintenance section of this manual). Copy this form as
needed. Direct any questions to the HAULOTTE® Customer Service Department at 1-800-537-0540 or
visit HAULOTTE® online at www.haulotte-usa.com.
Inspector : Initial in the space provided beside each service check as it is completed. Sign and date form after
Inspection.
Owner : Keep this form for your records.
Frequency key :
D = Daily (or before each use); W = Weekly; M = Monthly; A = Annually; SA = Semi-Annually
Service check descriptions Frequency Initials
Verify that all decals are legible, correctly applied, and in plain
view.
D
Verify that all controls and indicators at the ground (lower) and
platform (upper) control stations operate properly.
D
Verify operation of running and brake lights. D
Verify proper tire inflation. See the side wall of the tire for proper
inflation.
D
Inspect tires for damage or loose or missing lug nuts. D
Inspect structural components for obvious damage or debris. D
Inspect machine for loose, damaged or missing fasteners,
including pins and bolts.
D
Verify that the boom down limit switches operate correctly. D
Verify that outrigger safety interlocks operate correctly. D
Inspect hydraulic system and fluid levels. D
Check Battery electrolyte level. W
Inspect electrical wiring for damaged, broken or frayed wires. W
Inspect transport hitch for damage ; if fitted. W
Inspect boom for missing, loose or damaged hardware. W
Inspect all hydraulic system components including power unit,
hoses and cylinders, for damage, leaks, loss of pressure or
speed, and unusual noise or vibration.
W
Check engine oil. Applicable for machines equipped with
engines.
W
Clean all battery terminals. M
Check battery connections. M
Verify proper operation of manual lowering valves and hand
pump.
M
Lubricate all compartment hinges and latches, slew ring and
mating gear using NLGI Grade 2 multi-purpose grease.
M
Check wheel nut torque. M