Haulotte HTT13 - General

A
B
C
D
E
F
G
H
I
97 4000670450 E 04.19 USA / GB
F - Maintenance
3632T - HTT13
Maintenance
1 - General
As an owner and/or operator of Haulotte equipment, your Safety is of utmost importance
to HAULOTTE® , which is why HAULOTTE® places such a high priority on product safety.
INSPECTIONS are not only required by HAULOTTE®, but may also be required by industry standards
and/or governmental regulations.
To ensure that your equipment continues to perform to the factory set performance levels, it is
important that you regularly maintain your equipment and avoid making any modifications that are not
approved by HAULOTTE®. Regular and timely inspections will reduce equipment down time as well
as prevent possible injury.
N.B.-:-DO NOT OPERATE
UNLESS YOU ARE FAMILIAR AND TRAINED IN THE PRINCIPLES OF SAFE
MACHINE
OPERATION.
Overview :
• Walk-around inspections take only a few minutes at the beginning and end of each shift – one of the
best ways to prevent mechanical problems and safety hazards.
What to Do :
• Use your senses: sight, smell, hearing and touch.
Frequency :
• Check your machine periodically during your entire workday.
• Make sure to do your inspection the same way every time.
• Complete one of these inspections at the start and end of each shift.
N.B.-:-I
F DAMAGE OR UNAUTHORIZED MODIFICATIONS ARE DISCOVERED, THE MACHINE MUST BE
REMOVED
FROM SERVICE UNTIL REPAIRS ARE MADE BY A QUALIFIED SERVICE TECHNICIAN.
It is the owner's responsibility to ensure the required maintenance as recommended by Haulotte is
completed prior to the operation of the machine.
If regular maintenance is not carried out, this may :
• Void the warranty.
• Cause machine malfunction.
• Reduce machine reliability and shorten its service life.
• Jeopardize operator safety.
HAULOTTE Services® technicians are specially trained to carry out extensive repairs, interventions or
adjustments on the safety systems or elements of HAULOTTE® machines. They carry genuine
HAULOTTE spare parts and tools as required, and also provide fully documented reports on all work
completed.
The inspection and maintenance table, identifies the role and the responsibilities of each party in
periodical machine maintenance. Section C 3 - Inspection and Functional test.