12 4000670450 E 04.19 USA / GB
3632T - HTT13
A
- Foreword
2.1.3 - Overturning / Tip-over Hazards
Before positioning and operating the machine :
• Ensure that the surface is capable of supporting the machine weight
including the rated capacity. Check the load bearing capacity of the
supporting ground.
• Do not operate on surfaces that do not support force exerted by the
outriggers during aerial work platform operation.
• Do not exceed the maximum rated capacity that includes the weight of
both material and allowed number of occupants. Do not exceed the
allowable number of occupants.
• Place the loads uniformly distributed on the platform floor.
• Do not increase the working height (using extensions, ladder, etc.).
• Do not place ladders or scaffolds in the platform or against any part of
this machine.
• Do not use the machine in winds exceeding the permissible limit.
• Do not increase the surface area of the platform exposed to wind. This
includes adding panels, mesh, banners. Be aware when working with
materials with a large surface area. This will add to the wind load on the
machine.
• Do not replace components critical to stability with components of
different weight or specification.
• Do not use the machine with material or objects hanging from the
guardrail or the boom.
• Do not pull or push towards any object outside of the platform. Do not
exceed the maximum allowable side force stated in the performance
specifications.
• Do not use boom or platform to push or pull or to lift any part of the
trailer.
• Do not use the machine to support any external structure.
• Do not use the machine to drag materials.
• Do not operate aerial work platform without outriggers fully extended or
when platform is not level.
• Do not raise the outriggers or move the trailer with materials or
personnel on board, or while boom is raised or extended.
To Next Page
Loading...
