Haulotte HTT13 - Automatic Engine Cut-Out; Outriggers

A
B
C
D
E
F
G
H
I
59 4000670450 E 04.19 USA / GB
C - Pre-operation inspection
3632T - HTT13
4.4 - AUTOMATIC ENGINE CUT-OUT
The engine automatically cuts out in the following conditions :
• The alternator is not functioning.
• Oil pressure is too low.
• The E-stop(s) is (are) pushed in.
• The machine is switched off.
4.5 - OUTRIGGERS
Verify that outrigger safety interlocks operate correctly :
• Begin with the outriggers fully extended and the aerial work platform leveled. Raise one
outrigger until the footpad is not in contact with the ground.
• Verify that boom functions are unresponsive when one outrigger is raised.
• Repeat this procedure for each outrigger.
• Raise all outriggers until the footpads are not in contact with the ground. Verify that all
outriggers status LEDs on the ground (lower) control box are unlit.
• Lower one outrigger until the footpad makes contact with the ground and the outrigger begins
lifting the trailer.
• If the LED is lit before the footpad makes contact with the ground or if the LED remains unlit
after the weight is transferred to the outrigger, the position switch or wiring is faulty.
• Repeat this procedure for each outrigger.
• Repair or replace as necessary.