51 4000670450 E 04.19 USA / GB
C
- Pre-operation inspection
3632T - HTT13
3 - Inspection and Functional test
3.1 - DAILY INSPECTION
Each day before the beginning of a new work session and with each change of operator, the machine
must be subjected to a visual inspection and a complete functional test.
In case of loose fasteners, refer to torque table value in maintenance book.
In case of leaks, replace the damaged part before use.
In case of structural part deformation, cracks, broken weld, paint chips, replace the part before use.
Sample of broken welds
Inspection Forms are provided to assist your inspection process.
We recommend these forms to be completed daily and stored to assist with your maintenance
schedule.
Each action is depicted in the daily inspection sheet using the following symbols.
• Never use a defective or a malfunctioning aerial work platform.
• If any item on the check list is marked "No" during the inspection; machine must be tagged and placed
out of service.
• Do not operate the machine until all identified items are corrected and it has been declared safe for
operation.
Visual inspection without
disassembly
Lubrication-Grease Functional adjustments
Drain Test and validate Tighten
Check levels Systematic replacement
Visual inspection with small
disassembly or movement needed
to reach the part. Replacement is
necessary.
Proof tests : Need HAULOTTE Services® authorization. For
countries where machines are not subject to controlled periodic
maintenance.
To Next Page
Loading...
