56 4000670450 E 04.19 USA / GB
3632T - HTT13
C
- Pre-operation inspection
Check coolant level. Applicable for machines equipped with
engines.
M
Inspect the air filter. Applicable for machines equipped with
engines.
M
Verify proper level sensor operation(Use outriggers to tilt
machine, try to operate boom functions. ).
M
Check drive belt tension. SA
Verify engine rpm. Applicable for machines equipped with
engines.
SA
Add or replace hydraulic oil and hydraulic filter annualy, replace
more frequently in dirty conditions.
A
Inspect pivot pins and cylinders, including rod ends for wear or
damage.
A
Visually inspect all welds for wear, damage or corrosion. A
Inspect outriggers for wear or damage. A
Inspect axle and parking brake, adjust as necessary. A
Load test all boom functions with a 227 Kg (500 lb) load (200 Kg
(440 lb) load if machine is equipped with jib/platform rotate).
A
Check slew ring for wear or damage. A
Replace Jib Bushings. A
** Refer to engine operators manual for recommended engine maintenance.
Inspector signature Date
Machine Model No. Serial No.
To Next Page
Loading...
