5 Pronrammina Tool Movements
5.4 Path Contours - Cartesian Coordinates
------mm__
The tool must move to the left of the programmed contour to com-
pensate its own radius.
------------------------
The tool must move to the right of the programmed contour to
compensate its own radius.
------------me----------
The tool moves directly to the end point.
/c
-3
FEEBRATEF? F=
c i
e’g’ ~~~ m
Enter the feed rate of the tool on the straight line, for example
100 mm/min.
Enter rapid tool traverse, F = FMAX.
d
f ME%xLLArnUS l3TJNC~QN M P
--Y
,
d
Enter a miscellaneous function, for example M3 (spindle on, clock-
wise rotation).
Resulting NC block: L IX-50 Y+ 10 Z-20 RR FIOO M3
-
5-10
TNC 370 -
To Next Page
Loading...
