4
Programming
4.2
Tools
Pocket table for tool changer
The table TOOLP.TCH is programmed for auto-
matic tool changers.
In the pocket table the following information is
assigned to the individual pocket numbers.
PROGRRHMING RN0
EDITING
. .
II
TOOLP .TCH MM
RCTL. )(
+10>000
NOML. x
+10,000
;
+20,000 +20,000
+30.000
;
+30,000
C +0,000 C +0,000 c3
Fig. 4.5: Tool pocket table
P Pocket number of the tool in the magazine
-
T
ST
F
Tool number TOOL NUMBER
If the tool that is so large that it blocks the adjacent pockets
-
in the tool magazine, you can lock the pockets before and
after it in MP7264 (see S. 12-6). SPECIAL TOOL
Tool is always returned to a certain pocket in the magazine FIXED POCKET
L
PLC
Tool pocket is locked
This function is not available yet
POCKET LOCKED
PLC STATUS
Overview: Information in tool pockettables
4-12
TNC 370 -
To Next Page
Loading...
