HEIDENHAIN TNC 370 - MIRROR IMAGE (Cycle 8)

8
Cycles
8.7 Cycles for Coordinate Transformations
\
MIRROR IMAGE (Cycle 8)
Application
This cycle makes it possible to machine the mirror
image of a contour in the working plane.
L
L
Activation
The MIRROR IMAGE cycle becomes active as
soon as it is defined:
Mirrored axes are identified in the status display by
the letter S.
l If one axis is mirrored, the machining direction
of the tool is reversed. This does not apply with
fixed cycles.
l If two axes are mirrored, the machining direc-
tion remains the same.
The mirror image depends on the location of the
datum:
l If the datum is located on the mirrored contour,
the part is mirrored directly at the datum.
l If the datum is located outside the mirrored
contour, the part is mirrored and also jumps to
another location.
Fig. 8.71: MIRROR IMAGE cycle
:7
Fig. 8.72: Multiple mirroring and milling direction
Input data
Enter the axis that you wish to mirror. The tool axis
cannot be mirrored.
Cancellation
To cancel a mirror image, answer the dialog query
with NO ENT.
Fig. 8.73: Datum lies outside the mirrored contour
TNC 370
8-63