4 Programming
4.2 Tools
Entering tool data in program TO0L.T
The data for all tools can be entered in a common tool table. The number
of tools in the table is selected through the machine parameter MP 7260.
With MP7266 you can determine which data can be entered in the tool
table as well as the sequence in which they appear (see page 12-6).
4
d
If your machine uses an automatic tool changer or if you are working with
the automatic tool measurement function, the tool data must be stored in
the tool table.
Editing the tool table (program TO0L.T)
~~ffi~~~~~~~~
Call the program directory.
k
I /
r
>
PRQGRAM NAME =
-
J
Select the tool table.
Diaiog guiddame in the tooi tabk?
Confirm the entered value, select the next
column in the table
Clear an incorrect numerical entry
Recall the last stored value
Move the highlight one column to the left/right
Move the highlight one line up/down
Page one screen upward
Page one screen downward
Answer yes to a dialog question
Answer no to a dialog question
r--
NO
\,
/
4-8
TNC 370
To Next Page
Loading...
