HEIDENHAIN TNC 370 - Entering Tool Data into the Program

4
Programming
L
4.2 Tools
Entering tool data into the program
The following data can be entered for each tool in the part program:
l Tool number
l Tool length compensation value L
l Tool radius R
The dialog initiation soft keys are located in the third soft key row
To enter tool data in the program block:
Designate the tool with a number, for example 5.
\ J
6 T
TOOL LENGTB L
I i
Enter the compensation value for the tool length, for example L = 10
J
f
,
TcmL RADRIS R
c
*’
Enter the tool radius, for example R = 5 mm.
L
Resulting NC block: TOOL DEF 5 L+lO R+5
J
I!!!
* ‘&u can mm the tool feng?h and tad raffius IS m actual positim by pressing the ACrtJAt PCS. X, ACTUAL
POS. Y or ACTUAL PQS. Z saft key.
* If you are using program TOOL.T, enter toot rrunbers that are tarper than 99 in the ‘7301, EEF block.
TNC 370 4-7