HEIDENHAIN TNC 370 - Output through an External Data Interface; Assigning Values for the PLC

7
Programming with Q Parameters
\
7.6 Output of Q Parameters and Messages
ErrQr c&e Error text
1012
WRONG SIGN PROGRAMMED
L
. .
;-
1013 ENTERED ANGLE NOT PERMITTED
1014 TOUCH POINT INACCESSIBLE
1015 TOO MANY POINTS
1016 CONTRADICTORY ENTRY
1017 CYCL INCOMPLETE
1018 PLANE WRONGLY DEFINED
1019 WRONG AXIS PROGRAMMED
1020 WRONG RPM
1021 RADIUS COMP. UNDEFINED
1022
ROUNDING-OFF UNDEFINED
1023 ROUNDING RADIUS TOO LARGE
1024 PROGRAM START UNDEFINED
1025 EXCESSIVE SUBPROGRAMMING
1026 ANGLE REFERENCE MISSING
Output through an external data interface
The function FN 15: PRINT transmits the values of Q parameters and
error messages over the data interface. When FN 15 is used for trans-
ferring values to a PC, the TNC generates the file %FN15RUN.A in the
PC memory to store the transferred values.
l FN 15: PRINT with numerical values up to 200
Example: FN15: PRINT 20
Transmits the corresponding error message (see overview for FN14)
l FN 15: PRINT with Q parameter
Example: FN15: PRINT Q20
Transmits the value of the corresponding 0 parameter.
Up to six Q parameters and numerical values can be transmitted
simultaneously. The TNC separates them with slashes,
Example: FNI 5: PRINT l/Ql/2/Q2
Assigning values for the PLC
Function FN19: PLC transmits up to two numerical values or
Q parameters to the PLC.
L
L
Input increment and unit of measure: 1 mm or 0.001”
Example: FNI 9: PLC=+l O/+03
The number 10 corresponds to 10 mm or 0.01’.
TNC 370
7-l 3