HEIDENHAIN TNC 370 - Manual Operation and Setup

2
Manual Operation and Setup
2.1 Moving the Machine Axes ................................................................. 2-2
Traversing with the axis direction keys.. ................................................................. .2-2
Traversing with the electronic handwheel .............................................................. .2-3
Working with the HR 330 electronic handwheel.. ...................................................
.2-3
Positioning with manual data input ......................................................................... .2-4
Incremental jog positioning .....................................................................................
.2-4
2.2 Spindle Speed S, Feed Rate F and Miscellaneous Functions M . . 2-5
To enter the spindle speed S .................................................................................. .2-5
To change the spindle speed S .............................................................................. .2-5
To change the feed rate F.. ..................................................................................... .2-6
To enter the miscellaneous function M.. ................................................................. .2-6
2.3 Setting the Datum without a 3D Touch Probe ................................. 2-7
Setting the datum in the tool
axis
...........................................................................
.2-7
Setting the datum in the working
plane .................................................................. .2-8