1 Introduction
1.3 Switch-On
Switch-m and traversing the reference points can vary dspending on the individual machine tool. Your machine
manuel provides mare information an these functions.
-,
Switch on the power supply for control and machine. The TNC 370 then
begins the following dialog:
The memory of the TNC is automatically checked.
I
Message from the TNC indicating that the power was interrupted.
Clear the message.
Switch on the control voltage.
The TNC checks the functioning of the EMERGENCY STOP circuit.
Cross the reference marks manually by using the machine direction
keys, or
------Me---------------
Cross the reference points in several axes at once:
Select appropriate axes (the selected axes are highlighted on the
screen).
Start the function for traversing reference marks
The TNC is now ready for operation in the
MANUAL OPERATION mode.
To Next Page
Loading...
