HEIDENHAIN TNC 370 - 2 Manual Operation and Setup

2 Manual Operation and Setup
2.1 Moving the Machine Axes
.................................................................
2-2
Traversing with the axis direction keys .....................................................................
2-2
Traversing with the electronic handwheel
................................................................ 2-3
Working with the HR 330 electronic handwheel .......................................................
2-3
Positioning with manual data input ...........................................................................
2-4
Incremental jog positioning .......................................................................................
2-4
2.2 Spindle Speed S, Feed Rate F and Miscellaneous Functions M
...
2-5
To enter the spindle speed S ....................................................................................
2-5
To change the spindle speed S
................................................................................
2-5
To change the feed rate F
........................................................................................ 2-6
To enter the miscellaneous function M
.....................................................................
2-6
2.3 Setting the Datum without a 3D Touch Probe
.................................
2-7
Setting the datum in the tool axis ............................................................................
.2-7
Setting the datum in the working plane
.................................................................... 2-8
TNC 370