HEIDENHAIN TNC 370 - Cycles

L
.-
Cycles
8.1
8.2
8.3
8.4
8.5
8.6
8.7
8.8
General Overview of Cycles
................................................................
8-2
Programming a cycle
.................................................................................................
8-3
Drilling Cycles
......................................................................................
8-5
PECKING (Cycle 1)
....................................................................................................
8-6
DRILLING (Cycle 200) ...............................................................................................
8-7
REAMING (Cycle 201)
...............................................................................................
8-8
BORING (Cycle 202) ..................................................................................................
8-9.
UNIVERSAL DRILLING CYCLE (Cycle 203).
............................................................ 8-l 0
TAPPING with a floating tap holder (Cycle 2)
..........................................................
8-l 2
RIGID TAPPING (Cycle 17) ......................................................................................
8-13
Examples for exercise
.............................................................................................
8-l 4
Cycles for Milling Pockets, Studs and Slots
...................................
8-16
POCKET MILLING (Cycle 4)
....................................................................................
8-l 7
POCKET FINISHING (Cycle 212)
.............................................................................
8-l 8
STUD FINISHING
(Cycle 213). .................................................................................
8-20
CIRCULAR POCKET MILLING (Cycle 5)
..................................................................
8-22
CIRCULAR POCKET FINISHING (Cycle 214).
..........................................................
8-23
CIRCULAR STUD FlNlSHlNG
(Cycle 215) ...............................................................
8-25
SLOT MILLING (Cycle 3) .........................................................................................
8-27
SLOT with reciprocating plunge-cut (Cycle 210)
.....................................................
8-28
CIRCULAR SLOT with
reciprocating plunge-cut (Cycle 210).
..................................
8-30
Examples for exercise
.............................................................................................
8-32
Cycles for Machining Hole Patterns
.................................................
8-34
CIRCULAR PAlTERN (Cycle 220)
...........................................................................
8-35
LINEAR PATERN (Cycle 221)
................................................................................
8-36
Examples for exercise
.............................................................................................
8-38
SL Cycles ............................................................................................
8-40
CONTOUR GEOMETRY (Cycle 14)
.........................................................................
841
ROUGH-OUT (Cycle 6)
............................................................................................
8-42
SL Cycles: Overlapping contours
............................................................................
8-44
PILOT DRILLING (Cycle 15) ....................................................................................
8-50
CONTOUR MILLING (Cycle 16)
.............................................................................
8-51
Cycles for Multipass Milling
.............................................................
8-54
MULTIPASS MILLING (Cycle 230)
..........................................................................
8-55
RULED SURFACE (Cycle 231)
.................................................................................
8-57
Examples for exercise
.............................................................................................
8-59
Cycles for Coordinate Transformations
..........................................
8-60
DATUM SHIFT (Cycle 7).
.........................................................................................
8-61
MIRROR IMAGE (Cycle 8) .......................................................................................
8-63
ROTATION (Cycle 10).
.............................................................................................
8-65
SCALING FACTOR (Cycle 11)
.................................................................................
8-66
Special Cycles
....................................................................................
8-68
DWELL TIME (Cycle 9)
............................................................................................
8-68
PROGRAM CALL (Cycle 12)
....................................................................................
8-68
ORIENTED SPINDLE STOP (Cycle 13)
....................................................................
8-69