1
Introduction
\
1.4 Graphics and Status Display
L
Status display
The status display in the lower part of the screen
provides the following information:
l
Type of position values (ACTL, NOML, . ..).
The type of position values is selectable via
MOD function)
l
Axis is clamped ( m is shown in front of the axis)
l
T:
Number of the current tool
l
X or Y or Z: Active tool axis
l s:
Active spindle speed
l
F: Active feed rate
l
M: Active miscellaneous
functions
l
Spindle power indicated by a moving bar
graphic
l
TNC is in operation (indicated with YE)
l
On machines with different gear ranges:
Gear range indicated behind the ‘I/’ character
(depends on setting of machine parameter)
l
The current mode of operation (above the soft
keys)
l
The number of available soft-key rows; active
soft-key row is highlighted (beneath the soft
keys)
PROGRRH RUN, FULL SEQUENCE
3
4 L 2+100 RO FHRX
5 CYCL DEF 200 DRILLING
6 L X+20 Y+15.5 R0 FMAX M3
7 LBL 1
8 L 1X+12,5 R0 FHRX M99
9 CALL LBL
1
REP 5
Fig. 1.30:
Status display in a program run mode of operation
Additional status displays
The additional status displays contain further
information on the program run. With the SELECT
SCREEN LAYOUT key (see page l-4) you can
change the arrangement of the two status win-
dows in the right half of the screen:
General program information
Positions and coordinates
rx-,iH51,
Tool information
Coordinate transformations
r-
TEXT ‘\,
COORO.TRANS. /
STRTUS /
Results of automatic tool measurement
TEXT
r-
‘\
TOOL PROSE i
STRTUS /
TNC 370
1-31
To Next Page
Loading...
