7 Programming with Q Parameters
4
7.6 Output of Q Parameters and Messages
Displaying error messages
With the function FN14: ERROR you can call messages that were pre-
programmed by the machine tool builder.
If the TNC encounters a block with FN 14 during a program run or test
run, it interrupts the run and displays an error message. The program
must then be restarted.
Input example:
FN 14: ERROR = 254
The TNC will display the text of error code 254.
Error oode ta be *tiered
Prepared dialog text
0
to
299 FN 14: ERROR CODE 0 to 299
300 to 399
PLC: ERROR 0 to 99
400 to 499 DIALOG 0 to 99
d
1000 to 1099 Internal error messages
(see table below)
Error code
1000
Error text
SPINDLE MUST BE TURNING
1001
TOOL AXIS IS MISSING
-
1002
SLOT WIDTH TOOL LARGE
1003 TOOL RADIUS TOO LARGE
1004 RANGE EXCEEDED
START POSITION INCORRECT
1006 ROTATION NOT PERMITI-ED
1007 SCALING FACTOR NOT PERMITTED
1008 MIRRORING NOT PERMITTED
1009 DATUM SHIFT NOT PERMITTED
1010
FEED RATE IS MISSING
1011 ENTRY VALUE INCORRECT
7-12 TNC370 -
To Next Page
Loading...
