HEIDENHAIN TNC 370 - 7.5 Checking and Changing Q Parameters

7 Programming with Q Parameters
7.5 Checking and Changing 0 Parameters
Q parameters can be checked during program run or during a test run,
and changed if necessary.
Preparation:
l A running program must be aborted (e.g. press machine STOP button
and STOP soft key).
) If you are doing a test run, you must interrupt it.
To call a 0 parameter table
You can call a 0 parameter table by pressing the
black Q-key (see Fig. 7.4) in which the currently
active Q parameter values are filed.
Use the black arrow keys to select a Q parameter
on a screen page. With the arrow soft keys you can
move to the next or previous page of the table.
You can change a Q parameter value by overwrit-
ing the old value. Press END to exit the table and
save all changed values.
TEST RUN
15
Q0
=a
= +2
;; =
-15
ii
q +25.36
q +105
Q5 = -23
K
= +111,3
= +0
08 = +15
Q9 = +19
Ql0 = +22
RCX. x
-25,500 T
r
+21,325 q 0
+150,000 M5/9
C +90,000
L
Fig. 7.4: Q parameter table
\
TNC 370
7-11