1
Introduction
d
1.4 Graphics and Status Display
Projection in three planes
rE--)
Here the program is displayed as in a technical
drawing. The symbol left of the drawing indicates
whether the display is in first angle or second
angle projection according to IS0 6433, Part 1.
The type of projection can be selected with
MP 7310.
Moving the sectional planes
The sectional planes can be moved to any
position.
The position of the sectional plane is displayed on
the screen while it is being moved.
Fig. 1.25: TNC graphics, projection in three planes
f34+
t
Fig. 1.26: Move sectional planes In the display mode “projection in
three planes”
Shift the soft-key row
Shift the vertical sectional plane to the right or left.
d
4
d
-
-
IT,s’or~)~
Shift the horizontal sectional plane upwards or downwards
To Next Page
Loading...
