HEIDENHAIN TNC 370 - 3 Test Run and Program Run

3 Test Run and Program Run
3.1
3.2
3.3
3.4
3.5
Test Run
..............................................................................................
3-2
To do a test run
......................................................................................................... 3-2
Program Run
........................................................................................
3-3
To run a part program ................................................................................................ 3-3
Interrupting machining .............................................................................................. 3-4
Resuming program run after an interruption
............................................................. 3-5
Blockwise Transfer: Executing Long Programs
................................ 3-6
Skipping Blocks During Program Run/Test Run
............................ 3-7
Optional Interruption of a Program Run ..........................................
3-7
- TNC370