HEIDENHAIN TNC 370 - 3.2 Program Run

3
Test Run and Program Run
\-
3.2 Program Run
In the PROGRAM RUN / FULL SEQUENCE mode of operation the TNC
executes a part program continuously to its end or up to a program stop.
In the PROGRAM RUN / SINGLE BLOCK mode of operation you execute
each block separately by pressing the NC start key.
The following functions can be used during a program run:
l Interrupt program run
l Start program run from a certain block
l Blockwise transfer of very long programs from external storage
l Checking/changing Q parameters
To run a part program
l Clamp the workpiece to the machine table,
l Set the datum.
l Select the program.
lRBoIm/
Select the first block of the program.
1 Run the part program.
I
Only in mode
PROGRAM RUN /
SINGLE BLOCK
Run each block of the part program separately.
I
repeatedly
I
I
I!!!3
The feed rate and spindle spesd can be changed with the override knobs.
TNC 370
)I
3-3