HEIDENHAIN TNC 370 - 1.6 Programs

1 Introduction
J
1.6 Programs
The TNC can store up to 64 part programs at once. The programs can
be written in HEIDENHAIN plain language dialog or IS0 format.
Each program is identified by numbers or letters with up to 8 characters.
Program management
Action Operating
Call program
mode
management with . . .
The program management is called with the PGM
MGT soft key. In the program management,
Create (a program)
programs can be input/output, protected, copied,
.
renamed and erased.
Edit
The individual functions are selected by pressing
the corresponding soft keys.
The program directory provides the following
information:
l Program name
l Program type .H (HEIDENHAIN plain language)
l Program type .I (ISO)
l Program type .T (tool table)
. Program type .TCH (pocket table)
l Program size in byte (1 byte = 1 character)
l Program status:
M:
P:
Program is selected in a
PROGRAM RUN operating mode
Program is protected
Input/Output
EB
$3/j
Protect
COPY
Rename
Erase
Execute
QQ tB
.-
PROGRRM SELECTION
<I
1 .H 234 M
15687
108
ZJZK
?I
RLBERT .H 1~~
CYCLS
.H 1304
135K2 .I
-H
PkT :I
2::
108
TOOL .T 8224 M
TOOLP .TCH 36 M
RCTL. x
-25,500 T
;
+21,325 0 0
+150>000
M5/9
C +90,000
COPY ‘i
/
R E N R M E “1)
,’
I’
CLERR \
PGM ,!
Fig. 1.38: Program directon/ on the screen
4
-
1-36
TNC 370 -