HEIDENHAIN TNC 370 - ORIENTED SPINDLE STOP (Cycle 13)

8
Cycles
L
8.8 Special Cycles
ORIENTED SPINDLE STOP (Cycle 13)
Application
i
The control can address the machine tool spindle as a 5th axis and turn
it to a certain angular position. Oriented spindle stops are required for:
l Tool changing systems with a defined tool change position
l Orientation of the transmitter/receiver window of the TS 630 Touch
Probe System from HEIDENHAIN
Activation
L
The angle of orientation defined in the cycle is positioned to with M19. If
Ml 9 is executed without a cycle definition, the machine tool spindle will
be oriented to the angle set in the machine parameters.
‘-
L
Fig. 8.74: Oriented spindle stop
&
Oriented spindle stops can alto be programmed in machine parameters.
Prerequisite
The machine must be set up for this cycle.
Input data
Angle of orientation (based on the angle reference axis of the working
plane)
Input range: 0 to 360”
Input resolution: 0.1’
TNC 370
&69