1
Introduction
-
1.4 Graphics and Status Display
Detail magnification
Details can only be magnified in the 3D view
display mode.
The abbreviation MAGN appears on the screen to
indicate that the image is magnified.
Fig. 1.29: Detail magnification of a 3D graphic
Shift the soft-key row.
Select the side to be moved
E) or m; Reduce or enlarge workpiece.
L
/ E) 1 Transfer detail.
Repeating graphic simulation
A part program can be graphically simulated as often as desired, either
with the complete workpiece blank or with a detail
of it.
Restore workpiece blank as it was last shown
RESET
\
\
BLK
FORM ’
i
Show the complete BLK FORM as it appeared
before a detail was magnified via TRANSFER
DETAIL
-
J
4
d
I-30
TNC 370 -
To Next Page
Loading...
