HEIDENHAIN TNC 370 - Page 84

4
Programming
4.2 Tools
CUT.
LTOL
Number of cutting edges that are measured in automatic
tool measurement (20 cutting edges maximum) NUMBER OF TEETH ?
Permissible deviation from tool length L for monitoring
wear. If the entered value is exceeded, the TNC locks the
tool (status L). Input range: 0 to 0.9999 mm
0: Wear monitoring is not active WEAR TOLERANCE: LENGTH ?
RTOL Permissible deviation from tool radius R for monitoring
wear. If the entered value is exceeded, the TNC locks the
tool (status L). Input range: 0 to 0.9999 mm
0: Wear monitoring is not active
WEAR TOLERANCE: RADIUS ?
DIRECT.
Cutting direction of the tool for dynamic tool measurement
CU-I-TING DIRECTION ( M3 = -)
TT:R-OFFS Offset between stylus center and tool center
Default setting: Tool radius R
TOOL OFFSET: RADIUS ?
TT:L-OFFS Tool end offset in addition to MP 6530 (see page 12-5) from
top of stylus.
Default setting: 0
TOOL OFFSET: LENGTH ?
LBREAK Permissible deviation from tool length L for monitoring
breakage. If the entered value is exceeded, the TNC locks
the tool (status L). Input range: 0 to 0.9999 mm
0: Breakage monitoring is not active BREAKAGE TOLERANCE: LENGTH ?
RBREAK Permissible deviation from tool radius R for monitoring
breakage. If the entered value is exceeded, the TNC locks
the tool (status L). Input range: 0 to 0.9999 mm
0: Breakage monitoring is not active BREAKAGE TOLERANCE: RADIUS ?
Overview: lnformatton in tool tables forautomatic tool measurement
L
TNC 370
4-11