5
Programming Tool Movements
4
5.6 Path Contours - FK Free Contour Programming
Free programming of straight lines
Direct data for straight lines or end points of straight lines
Knaiun data
Dialag
X coordinate X-COORDINATE ?
Soft key
Y coordinate Y-COORDINATE ?
Polar coordinate radius POLAR-COORDINATE RADIUS ?
Polar coordinate angle POLAR-COORDINATE ANGLE ?
Length of a straight line LENGTH OF EDGE ?
Gradient angle of a straight line SLOPE ?
Begin/End of a closed contour
CLOSED CONTOUR: BEGIN/END = +/-
5-40 TNC 370
To Next Page
Loading...
