HEIDENHAIN TNC 370 - Page 141

5
Pronrammind Tool Movements
5.6
Path Contours - FK Free Contour Programming
Values given relative to another contour element, auxiliary points
Knovun data
Straight line parallel to
another contour element
Dialag
S& by
LINE PARALLEL TO BLOCK ?
Distance from a straight line
to a parallel element
DIST. BETWEEN PARALLEL LINES ?
X coordinate of an auxiliary point AUXILIARY POINT 1 X-COORDINATE ?
on a contour
Y coordinate of an auxiliary point
on a contour
AUXILIARY POINT 1 Y-COORDINATE ?
X coordinate of an auxiliary point DIST AUXIL POINT PD X-COORDINATE ?
at distance D
Y coordinate of an auxiliary point DIST AUXIL POINT PD Y-COORDINATE ?
at distance D
Distance from an auxiliary point
to a straight line
DISTANCE FROM AUXILIARY POINT ?
d
d
d
.--
.-.
-..
-
5-42
TNC 370 -