HEIDENHAIN TNC 370 - 5.8 Positioning with Manual Data Input (MDI)

5 Programming Tool Movements
L
5.8 Positioning with Manual Data Input (MDI)
L
‘-
In the POSITIONING WITH MANUAL DATA INPUT mode you can pro-
gram:
l Single-axis positioning blocks with the corresponding soft keys
l Linear blocks with path function key L
l Tool call (spindle speed) with the TOOL CALL soft key
The entered positioning blocks are not stored.
Application example
To correct workpiece misalignment on a rotary table
Preparation:
Perform a basic rotation with the 3D touch probe system; write down the
ROTATION ANGLE and cancel the basic rotation again.
Select the positioning with MDI mode of operation.
l Program the desired rotation
-
/
.
Enter the ROTATION ANGLE for the rotary table axis that you previously wrote down.
.
Enter RO, FEED RATE.
Conclude entry.
The table rotates to correct the misalignment.
\I
TNC 370 5-57