1 Introduction
1.1 TNC 370
Screen Layout
The screen layout is selected with the
These are the available layouts:
key.
Modes of apcarcvtion
PROGRAM RUN, FULL SEQUENCE
PROGRAM RUN, SINGLE BLOCK
TEST RUN
!breen layout
Program text
Left: Program text
Right: Program information
Left: Program text
Right: Additional position display
Left: Program text
Right: Tool information
Left: Program text
Right: Active coordinate transformations
(Not in the TEST RUN mode of operation)
Left: Program text
Right: Results of automatic tool measurement
PROGRAMMING AND EDITING
Program text
Programming graphics
Left: Program text
Right: Programming graphics
Left: Program text
Right: Graphics only during cycle programming
The screen layout cannot be changed in the MANUAL, HANDWHEEL
and POSITIONING WITH MANUAL DATA INPUT modes.
-/
J
.,
-/
-
-/
.-
-
1
-/
d
1-4
TNC 370 -
To Next Page
Loading...
