HEIDENHAIN TNC 370 - Page 242

8
Cycles
L
8.5 SL Cycles
Example: Overlapping pockets with islands
Inside machining with pilot drilling, roughing out
and finishing.
PGM 360830 is based on 360825:
The main program has been expanded by the
cycle definitions and cycle calls for pilot drilling
and finishing.
The contour subprograms 1 to 4 are identical to
those in PGM 360825 (see page 8-49) and are
to be added after block 39.
0 BEGIN PGM 360830 MM
1 BLK FORM 0.1 Z X+0 Y+O Z-20
2 BLK FORM 0.2 X+100 Y+lOO Z+O
3 TOOL DEF 1 L+O R+2.2 _.............____._.__.,........... Drill
4 TOOL DEF 2 L+O R+3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Rough
mill
5 TOOL DEF 3 L+O R+2.5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Finish
mill
6
CYCL DEF 14.0 CONTOUR GEOM.
7 CYCL DEF 14.1 CONTOUR LABEL l/2/3/4
8 CALL LBL IO
9
10
11
12
13
14
15
16
STOP M6
TOOL CALL 1 Z S 2000
CYCL DEF 15.0 PILOT DRILL
CYCL DEF 15.1 SET UP 2 DEPTH -10
CYCL DEF 15.2 PECKG 5 F500 ALLOW +2.8
L Z+2 RO FMAX
CYCL CALL M3
CALL LBL 10
17
18
STOP M6
TOOL CALL 2 Z S 1750
Pilot drilling
19
CYCL DEF 6.0
ROUGH-OUT
20 CYCL DEF 6.1 SET UP 2 DEPTH -10
21
CYCL DEF 6.2 PECKG 5 FIOO ALLOW +2
22 CYCL DEF 6.3 ANGLE +0 F500
Rough-out
23 L Z+2 RO FMAX
24 CYCL CALL M3
25 CALL LBL 10
26
27
28
29
30
31
32
33
STOP M6
TOOL CALL 3 Z S 2500
CYCL DEF 16.0 CONTOUR MILLING
CYCL DEF 16.1 SET UP 2 DEPTH -10
CYCL DEF 16.2 PECKG 5 FIOO DR- F500
L Z+2 RO FMAX
CYCL CALL M3
CALL LBL 10
Finishing
34
L Z+20 RO FMAX M2 . . . . . . . . . . . ..____...................... Retract and return jump
35 LBL 10
36 TOOL
CALL 0 Z . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Tool change
37 L Z+lOO RO FMAX
38 L X-20 Y-20 RO FMAX
39 LBL 0
From block 40: add the subprograms listed on page 8-49
63 END PGM 360830 MM
TNC 370 8-53