9 3D Touch Probes
L
9.2 Touch Probe Cycles in the MANUAL and ELECTRONIC HANDWHEEL Operating Modes
Select the second coordinate.
r
DATUM Y=
i ,,,
-3
J
Enter the second coordinate of the datum, for example in the Y axis.
Confirm with ENT.
Terminate the probe function.
If you do not wish to use points that were just probed for a basic rotation
/
\
TOUCH I%M.NTS OF BASIC ROTATIOW!
J
Ignore the dialog prompt.
j
Probe both workpiece sides twice.
1
I
Enter the datum coordinates.
I
L
TNC 370 9-l 1
To Next Page
Loading...
