9 3D Touch Probes
\-
9.2 Touch Probe Cycles in the MANUAL and ELECTRONIC HANDWHEEL Operating Modes
Outside circle
I
Fig. 9.12:
Probing an outside cylindrical
surface to find the center
Select the probe function for datum setting at a circle center.
Move the touch probe to a starting position near the first touch point @ outside of the circle.
Select the probing direction.
Probe the workpiece.
Repeat the probing process for points 0, @ and @ (see Fig. 9.12).
I
Enter the coordinates of the circle center.
After the probing procedure is completed, the TNC displays the current
coordinates of the circle center and the circle radius PR.
I
L
TNC 370
9-13
To Next Page
Loading...
