9 3D Touch Probes
4
9.5 Using Digitized Data in a Part Program
Executing a part program from digitized data
Before the digitized data program can be transferred blockwise (see
page 3-6). it must be called into another program containing the following
data:
l
Tool radius and length
l
Feed rate of tool
l
Radius compensation
l
Spindle axis and rpm
l
Miscellaneous function for spindle ON
Program example:
r
0 BEGIN PGM 444 MM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Any number
1 TOOL DEF 1 L+30 R+4 ._.__................................ Tool data
2
TOOL
CALL 1 Z SIOOO . . . Tool axis and spindle speed in rpm
3 L RO F500 M3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No tool radius compensation
4
CALL PGM EXT:34891
.H . . . . . . . . . . ..__.._______...... Call the file in which the digitized data are stored.
5 END PGM 444 MM
W +&e end of the surface data program from the CONTOUR LINEG q&Ye the ‘cool is returned to the programmed
starting point.
9-30 TNC 370
To Next Page
Loading...
