HEIDENHAIN TNC 370 - Page 29

1 Introduction
1.1 TNC 370
4
PROGRAMMING AND EDITING mode of operation
The soft-key structure in the Programming and Editing mode varies
according to the selected screen layout (see page l-4). The structure
d
shown here applies for:
l TEXT
l TEXT+GRAPHICS
l TEXT+FIGURE
0
v
Set program label
Call program label
Stop program run
Define workpiece blank
0
v
Paraxial positioning
Paraxial positioning
0
v
Automatic draw function
on /off
Start graphics blockwise
4
_-
I
I\ Define cycle MEASURE
RBIUS/ TOOL RADIUS
IR,
\$ Define cycle CALIBRATE
i l-r120
Programmable probe function
RANGE digitizing cycle
(for digitizing option only)
MEANDER digitizing cycle
(for digitizing option only)
\ CONTOUR LINES digitizing cycle
/ (for digitizing option only)
r---y
i)
Jump back one level
! Enlarge zoom range
Reduce zoom range
_
-
-
-i
Start graphics from beginning
Start graphics from current
Show selected detail
Show the space defined in
-
I-IO
TNC 370 -