HEIDENHAIN TNC 370 - 11.1 Calling and Exiting the MOD Functions; 11.2 Machine-Specific User Parameters

11 MOD Functions
The MOD function provides additional display and input possibilities. The
available MOD functions are selected via soft key, or directly with ENT.
Machine-specific user parameters
Set traverse limits
Set the data interface
NC and PLC software numbers, show free
memory
Enter code number
I
4/
d’
-J
11 .I Calling and Exiting the MOD Functions
To select the MOD function
Press the MOD key.
If necessary, select the desired MOD function by soft key.
Once you have activated the MOD function you can immediately select
l the position display type
l the unit of measure
l the programming format
To leave the MOD function
r
e!!l
.’
Press the END block key.
11.2 Machine-Specific User Parameters
The machine tool builder can assign functions to up to 16 USER
PARAMETERS. For more detailed information, refer to the operating
manual for the machine tool.
11-2
TNC 370