HEIDENHAIN TNC 370 - Page 32

1 Introduction
L
1 .I TNC 370
PROGRAMMING AND EDITING, FK programming mode
F P 0 L ‘%I
d?/
0
v
Straight line .-+z)
Straight line, tangen- j
tial connection
Circle
Circular arc, tangen-
tial connection
Pole for FK functions
Automatic drawing on/off
Start graphics blockwise
Start graphics from
program beginning
Start graphics from
current block
Reset graphics
Enlarge zoom
range
Reduce zoom
range
Show selected detail
Show the space defined in
BLK FORM
End point X
End point Y
Polar coordinates -
radius of the end point
Polar coordinates -
angle of the end point
Contour beginning/
Contour end
Length of a straight line
Gradient angle of
a straight line
Parallel to block number
Distance between
parallel lines
Point at distance D,
X coordinate
Point at distance D,
Y coordinate
Point at distance D
Point on the contour,
X coordinate
Point on the contour,
Y coordinate
TNC 370
I-13