1
Introduction
L
1.1 TNC 370
. .
TEST RUN mode of operation
In the Test Run mode of operation the soft-key structure varies accord-
ing to the selected display mode. The TNC provided three structures:
SINGLE ON
“\
I---
1
BLOCK m /
Test run in Full Sequence/
Single block
Test run with/without graphics
RESET ‘\
L---f
f
START
i
Start test run from beginning
of program
Start test run from
current block
Test run up to block number
N
Plan view or fast internal image
generation is active:
Plan view
Projection in three planes
L
Y’2 \
b,, / 3Dvrew
Fast internal image
rGRiICS
) generation
RESET \
BLK
i Reset blank form
FORM
/
‘\ Block skip
o:! k i active/inactive
Projection in three planes
is active
1
n
j Plan view
Projection in three planes
1 g ,) 3Dview
RESET \
SLK
) Reset blank form
FORM I’
0
T
Move sectional plane
to the right
‘\ Move sectional plane
) to the left
‘1,. Move sectional plane
/
1’ upward
‘1% Move sectional plane
!’ downward
3D view
is active
Projection in three planes
Fast internal image
in positive direction
Move sectional plane
in negative direction
L
TNC 370
l-l 5
To Next Page
Loading...
