HEIDENHAIN TNC 370 - Page 93

4 Programming
4.4 Program Creation
4
Enter the tool axis, for example Z.
f
DEFRLKFfXtlkbMlON~CORIVER?
' e.g. 0"
Enter the MIN point coordinates for the X, Y and Z axes.
0”
r
I
DEFBLKKHtMzMAX-m-R?
c I
Enter the MAX point coordinates for the X, Y and Z axes.
The entered program section appears on the screen:
Block 0: Program beginning, name, unit of measure.
Block 1: Spindle axis, MIN point coordinates.
Block 2: MAX ooint coordinates.
4
3ENDPGM783MM
-
Block 3: Program end, name, unit of measure.
The unit of measure used in the program appears behind the program
name. You can select the desired unit of measure, mm or inch, with the
MOD function (see page 1 I-3).
4-20
TNC 370 -