HEIDENHAIN TNC 370 - 4.9 Entering Comments in the Part Program

4 Programming
4.9 Entering Comments in the Part Program
In the PROGRAMMING AND EDITING mode of
operation you can add comments to the part
program. They can be entered as separate blocks or
at the end of blocks.
Applications:
l Describing programming steps
l Adding general information
‘ROGRRHMING RND EDITING
1”
9 :FIRST HOLE 10 LBL 1 [ DEF ,!
11 L 1X+12,5 R0 FMAX M99
12 CRLL LBL 1 REP 5
CTL. x
-25,500 T
I
+21,325 q 0
+150,000 M5/9
C +90,000
Fig. 4.16: Adding comments to the part program
To enter comments
*
cl
9
Enter a semicolon.
1
Enter the comment by using the alphabetic and numerical keys.
Terminate the comment.
d
d
4
4
-
-
4
.-
-_
4-26
TNC 370 -