Mobile Video Recorder User Manual
2
Chapter 2 Start Up Device
Activation
You can activate the recorder via the SADP software, the Web, the client software or the local menu.
If you want to activate the device via the SADP software or the Web, make sure that the device and
your computer are in the same network segment.
If you want to activate the recorder via the local menu, you must connect the device to an external
monitor.
For the first-time access, you need to activate the recorder by setting an admin password. No
operation is allowed before activation.
The default setting of the recorder is as follows:
• Default IP: 192.168.1.64.
• Default user name: admin.
You can activate the recorder via the local menu when it's connected to an external monitor.
Enter the same password in Password and Confirm Password.
We highly recommend you to create a strong password of your own choosing (using a minimum of
8 characters, including at least three kinds of following categories: upper case letters, lower case
letters, numbers, and special characters) in order to increase the security of your product. And we
recommend you reset your password regularly, especially in the high security system, resetting the
password monthly or weekly can better protect your product.
Click OK.
SADP software is used for detecting the online device, activating the device, and resetting the
password. Get the SADP software from the supplied disk or the official website, and install the SADP
according to the prompts. Follow the steps to activate the camera.
Before You Start
Ensure your computer and the recorder are in the same network segment.
Install the SADP software in your computer.
Run the SADP software.
To Next Page
Loading...
