Mobile Video Recorder User Manual
5
You can add the activated IP cameras. Ensure the device and IP cameras are in the same network
segment.
Before You Start
The record and the camera to add must be in the same network segment.
Go to Configuration > System > Camera Management > IP Camera.
Optional: If the recorder and the camera are in different network segment, modify IP camera
address.
1) Check the IP camera and click Modify.
2) Enter IP Address and Password.
3) Click OK.
Select a camera and click Add.
If the recorder password is the same with the camera's, click Quick Add to add the camera.
Enter IP camera information.
Click OK.
You can visit, delete, and modify the added IP cameras.
Before You Start
If the recorder contains only one network card, you can visit IP camera via the recorder. If the
recorder contains dual network card, you need to enable virtual host function before visiting IP
camera via the recorder. Go to Configuration > Network > Advanced Settings > Other and check
Enable Virtual Host.
Go to Configuration > System > Camera Management > IP Camera.
Optional: Click address of IP camera to visit.
Optional: Check IP cameras and click Delete to delete added IP cameras.
Record and Capture
To record the videos for connected cameras, you need to install a storage media and format it, and
configure the recording schedule.
A newly installed storage media must be initialized before it can be used.
To Next Page
Loading...
Need help?
General