HIKVISION AE-MD5043 - Share Network Via Cable

Mobile Video Recorder User Manual
17
Connect a peripheral device to your recorder with a network cable. The peripheral device can access
internet after the recorder successfully dialed to internet.
Before You Start
Configure the IP address, gateway, etc. of the peripheral device.
Go to Configuration > Network > Basic Settings > TCP/IP > Lan.
Check Enable Network Share.
Configure the network parameters for the peripheral device.
1) Set its IP address in the same network segment with your recorder.
2) Set its network gateway IP as the recorder IP address.
Click Save.
The peripheral device can access internet after the recorder successfully dialed to internet.