Mobile Video Recorder User Manual
4
Chapter 3 Basic Operation
You can perform the basic operations once the recorder is connected to an IP camera.
All the operations from Chapter 3 to Chapter 11 is done via web browser.
Configure Date & Time
Configure time zone and time synchronization mode.
Go to Configuration > System > System Settings > Time Settings.
Select Time Zone according to the recorder location.
Select time synchronization mode as NTP or Manual Time Sync.
1) If an NTP server is available, select NTP and enter NTP server information to synchronize
NTP server time to your recorder.
2) Select Manual Time Sync. and set time to customize the recorder time.
3) Select Manual Time Sync. and check Sync. with computer time to synchronize the
computer time to your recorder.
Click Save.
Manage IP Camera
The section is only available for the recorder that supports network camera.
Before adding an IP camera, activate it by setting a password for it.
Go to Configuration > System > Camera Management > IP Camera.
Select an inactivated IP camera.
We highly recommend you to create a strong password of your own choosing (using a minimum of
8 characters, including at least three kinds of following categories: upper case letters, lower case
letters, numbers, and special characters) in order to increase the security of your product. And we
recommend you reset your password regularly, especially in the high security system, resetting the
password monthly or weekly can better protect your product.
Click Activation.
Enter the same password in New Password and Confirm.
Click OK.
To Next Page
Loading...
